So this Saturday we had a small job and I wanted to continue testing out our Xero system that we just got. I set it up and saw that the water pressure was low and water was barley clearing the brush from the rinse bar, so i connected the jets only on my tucker brush. I proceeded to clean the outside of the store but when I did the inside windows i saw a lot of dried water spots, so i had to redo those windows by hand. My question is, did the WFP leave these marks due to low pressure?
No it was your technique. There is a learning curve we suggest doing your home first to practice.
2 Likes
Imo you should use either di only or a pump with the rinse bar. I’ve had poor results in conjunction with ro/di.
1 Like
John i was thinking also that it might have been that i lifted the brush to much and the pencil jets might have caused it.
@Lukethat might be it. I was using ro/di combo
If you want to you the rinse bar I’d highly recommend purchasing a pump for best results.
1 Like
I do not think the jets would have been the cause. Spotting comes
From not enough scrub or rinse. Keep at it and you will be a pro in no time.
2 Likes
Agree . Spotting rarely comes from your equipment. I’d say its Technique
thanks guys. I’ll work on my technique
1 Like